Doesn't close the doors from the remote. That's the reason for the old-fashioned a91.

Starline A91 Starline A91 Automatic Security Mode In the full-activator option, most installers completely break the chains connecting its wrapping to the mainframe and powering it from a built-in alarm relay. The problems with the rewiring of the cliffs, the locks have the same symptoms as in the previous section. Starline A91 Starline A91 how to install automatic security. The signal to the brilliance comes when I launch the car via the app. And the key itself does not work, blinks the network indicator, and gives a strange, unusual signal not to melody as usual.

Contents:

• Starlines' automatic alarm does not open or close the door from the bell: correct the faults
• Malfunctions of StarLine auto alarms when opening/closed doors
• Starlines' automatic alarm does not open or close the door from the bell: correct the faults
• Malfunctions of StarLine auto alarms when opening/closed doors
• Why doesn't the car open from the alarm bar?
• Reasons for the failure of the Starline alarm when opening or closing from the lock

Starlines' automatic alarm does not open or close the door from the bell: correct the faults

It's a very simple way to reduce fuel consumption! You don't believe it? The summer mechanic didn't believe it either until he tried it. And now he's saving 35 rubles a year on petrol. Many of the specialized centres are setting up the system in a matter of hours, confined to disassembly of the instrument panel, one of the thresholds and a glove box. Once installed, it's found that a web of wires is formed under the wheel. Rewinded with a normal insulation. The main symptoms of incorrect installation are: Excess at the time of placing on guard.

If you have a lock sign on the lock when you ask for status, it must disappear as soon as you put the car on the guard, at the same time as the engine is jammed. Interference in the keyboard, due to the faulty setting, prevents the door from opening, so you have to press Valet, open the car and turn the system off manually.

In this case, it is necessary to check the route of installation of the plume of the communication module. It may not be placed separately as necessary in the installation technique, but it may be wrapped in a set of other alarm wires. Other problems can be detected by a complete review of the instrument panel and a view of the installation of the entire system. The problem with the broken wire In the transition between the body and the door, in the area where the rubber gofre is located, may be broken by the wire responsible for opening and closing the door.

In open state, the wiring bend can operate in normal operation, and in closing, the wire is unlocked. This problem can be checked as follows: leave the door open and latch it by placing a screwdriver or any other bar in the door latch. The effect must be the same as when the door is closed on the counter. Press the end of the door in the door aperture to allow electronic systems to recognize the closure. Place the vehicle on guard.

All locks shall be locked and the alarm shall indicate this by a single sound signal. If the opening has taken place, the handle shall be pulled onto the door to open the latch and slam it by repeating the entire process.

If the locks do not open then the problem is the breakage of the circuit responsible for unlocking. The failure in the central lock is the most vulnerable part of the Starline alarm in the control of the lock.

The problem is most common when the vehicle is simple for more than 1 minute in security mode, and when the vehicle is automatically launched, the security is removed from the vehicle in normal operation.

The problem is that the regular default key is not equipped to operate on a built-in machine. The installation and removal of the security is correct, but the central locks are not working. To solve the problem, it is necessary to set up two pulses, one of which is responsible for waking up the tyre and the other for opening the doors.

This helps to open the central lock in the commanded mode only by pressing the button. However, this action does not extend to opening the central lock of the trunk. The problem of opening doors after auto-starting After use, the start-up function of Starline alarm can block the automatic opening of doors even if removed from security.

In this situation, you have to use the key and open the machine manually. The problem may be caused by the faulty connection to the central lock control circuits during installation.

The solution requires the reconnecting of the two alarm wires responsible for the control of the lock, provided that there is no problem with the safety-belt circuits.

If the safety-belt plug is closed in the drivers' seat, the doors will not open. This indication indicates that the security is installed or removed from the door, but not that the door locks are unlocked or locked. None of the signals, including Starline, are able to control the opening and closing process of the central lock and at the same time display the operation on the locking screen. Problems after replacement of the battery after replacement of the battery, the door may not close, but the key will signal the vehicles' successful closing.

In this case, attention should be paid to the option of locking it back. To tie it back, it is necessary to turn off the ignition and press the Valet7 service button once. Activate the ignition. The system will then issue 7 signals, which indicates the activation of the Starline log mode. At the same time, press buttons 2 and 3 and hold it to the successful record signal. Repeat the previous paragraph for all recorded keys.

In this case, it is necessary to keep the interval of 5 seconds. The success of the operation is confirmed by the signal. Turn off the ignition. This will be followed by a five-time flashing of the position lamps notifying the end of the linkage. The problem of opening the doors after replacement of the battery may be caused by other reasons. First, the central lock connection to which the alarm unit is connected may be damaged.

Second, the alarm can burn on the alarm wire or the connection to the vehicle can be broken. Closing problems from Starline B alarm can lead to problems with closing the vehicle. The alarm system operates in the normal mode, but the doors remain open. The reason may be to disconnect the curtain under the drivers' seat. Therefore, the alarm cannot recognize the end of the door opening signal, resulting in the automatic installation of the vehicle in the security mode within 30 seconds.

The fuses in the alarm unit may also be damaged, which prevents the signal from being signaled. The diagnosis and resolution of this problem can be achieved in the following ways: Without removing the key from the ignition lock, it is necessary to open the drivers' door and then remove the key. Then slam the door and put it in the security mode. Disconnect and attach back the minuse to the battery. Pull the handbrake, pull the key, open the drivers' door, press the central lock button to ensure that all other doors close, close the drivers' door, and press the closing button on the key.

If the problem is not solved after the manipulation, the Starline Service Centre needs to be consulted and the system may be replaced with a warranty discussion, in which case the door can be shown on the keyboard as open. When the relevant key button is closed again and pressed on the key, the vehicle immediately opens and the alarm is activated.

The problem is caused not by the system itself but by the adjustment of the drivers' drivers' drivers' drivers' drivers' drivers' drivers' handler. It is not possible to reach the normal thrust and the end of the line does not allow the central lock to open the doors. In this case, there are two exits: Remove the drivers' side of the door and adjust the drivers' thruster.

Change the two-conductor activation to a similar system, but consisting of five wires. It is then necessary to give control of the central lock from the regular lock. It is worth noting that this is the most efficient method. After a long waiting period for the vehicle and removal from the security, there may be a problem of instant automatic closing of the doors. The problem is solved after a second push on the opening button.

Others may be damaged by the insulation of the wiring and in the main lock curtain, the fuse on the green and blue wires has burned. Mass lock is conducive to the spontaneous opening and closing of the doors. The problem may also be to find the equipment in service mode. In this case, the impact sensor will not be activated. In this case, the lock will alert the malfunction to a telltale showing the heating key. This icon is selected by button 3 and cut off by button 2.

You're tired of paying fines? There's a way out! Forget about the tickets from the cameras! More details on the link. Absolutely legal article.

Malfunctions of StarLine auto alarms when opening/closed doors

Let's say that Starline's automatic alarm doesn't close the door lock when the engine is running. The first thing to do for the car owner is to put new batteries in the lock. And the reason why the pad mechanism is out of operation will be found. If the signal is not sensitive, you will need to contact specialists to resuscitate or reboot the program in person.

The car is not closing. What can you do? What's the reason? If it's expected in cars with the simplest setup, because you have to collect the central lock from zero and set up all the drive, often of questionable quality, then it's not safe for the installer to have problems later.

Starlines' automatic alarm does not open or close the door from the bell: correct the faults

It's found a very simple way to reduce fuel consumption! Don't believe it? The machine with summer experience did not believe it either until it had tried it. And now it saves 35 rubles per year on petrol. Many of the specialized centres are setting up the system in a matter of hours, limited to cutting the instrument panel, one of the thresholds and a glove box. Once installed, it is discovered that a web of wires is formed under the wheel. Rewinded with a normal insulation. The main symptoms of the incorrect installation are: Explosion at the time the guard is placed on the guard. There is a lock on the lock when the condition is requested. It must disappear as soon as the vehicle is placed on the guard, at the same time as the engine is jammed.

Malfunctions of StarLine auto alarms when opening/closed doors

The alarm does not close the vehicle's 30 Jan Off video and does not open the alarm door. One of the most common reasons why the system does not open or close the car's doors is to block the engine, making it impossible to start it, to power it. In this case, the system may not respond to the clicks on the keybars, but the turns-ons are also not activated. Or the alarms in the car begin to perform actions you did not ask. If you unplug the remote control and change the battery, it will only take a few minutes.

.

Why doesn't the car open from the alarm bar?

.

.

Reasons for the failure of the Starline alarm when opening or closing from the lock

.

.

.

.

.

.

.